C0680
Electric Park Brake Module Internal Fault
Public evidence for C0680 is lacking: it is in none of the public J2012 tables, bulletins or maker indexes. The title describes a park brake controller that fails its own checks. How GM handles that is documented for the 2011 Saab 9-5, just under other numbers: C056E flags software that is missing, an absent calibration or implausible software, and C0558 a calibration or mechanical fault; depending on the case the brake is disabled outright or allowed one more release. In many current cars the park brake logic lives inside the ABS/ESC module, which drives both motors directly. After pad or caliper work the system must be put into maintenance mode and calibrated again, so a skipped calibration or interrupted programming is a likely trigger alongside a genuinely failed board.
Possible causes
- Calibration after brake service skipped or programming interrupted high
- Electronics inside the park brake or ABS/ESC module failed medium
- Low battery voltage during self-test or programming low
Symptoms
- Park brake warning, function disabled or degraded
- Brake cannot be applied, or only one more release is allowed
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0680
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2011/5-brakes/handbrake/fault-diagnosis-diagnostic-trouble-codes/dtc-c056e
- saabwisonline.com/9-5-9650/2011/5-brakes/handbrake/fault-diagnosis-diagnostic-trouble-codes/dtc-c0558
- vehicleservicepros.com/service-repair/undercar/article/21290213/push-button-parking-electronic-parking-brake-operation-and-diagnosis
- aftermarket.zf.com/en/media/master/downloads/xzm200.pdf