OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0670

Left Front Acceleration or Position Sensor Circuit

C0670 is absent from the publicly available J2012 lists, but GM assigns it in its electronic damping control. In Saab's 2011 workshop data for the 9-5 and 9-4X it covers the vertical acceleration sensor at the left front wheel, which the suspension module supplies with 5 V and which answers with 0.5 to 4.5 V. Subcode 02 sets when the signal remains below 0.5 V longer than 1.5 s, 05 when it remains above 4.5 V as long, and 0A when it changes too rarely for 2.5 s above 30 km/h. Variable damping is then switched off until the next ignition cycle and a suspension warning appears. GM bulletin PI0954 names C0670 among five accelerometer codes on the 2010 LaCrosse with real-time damping when a service sensor meets an early controller. Nothing public ties the code to the park brake; C0675 is the right-hand twin.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 70

Possible causes

  • Wheel acceleration sensor, its 5 V supply or signal wire faulty high
  • Replacement sensor not compatible with early suspension module (GM PI0954) medium
  • Corroded or loose connector at the wheel housing medium

Symptoms

  • Service suspension message in the instrument cluster
  • Adaptive damping inactive, firmer or less controlled ride

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0670

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication