C066F
Service/Park Brake Chamber Pressure Too Low
C066F reports chamber pressure below what the brake system needs. No maker documents this code. For the spring section the consequences are clear: inside Bendix's piggyback unit the main spring starts to apply the brake once its chamber pressure falls under 78 psi, so a leak or weak supply makes the brakes drag. UN Regulation 13 requires that the springs of a motor vehicle do not start acting above 80 % of the lowest normal pressure, and that the driver is warned when the feed to the spring chamber sinks far enough for the brake components to start moving. FMVSS 121 asks for a warning once the service reservoir falls below 60 psi. Haldex lets its trailer EBS monitor spring brake pressure through an extra 5 V sensor and light a lamp under a set limit.
Possible causes
- Leaking diaphragm, chamber seal or supply line high
- Insufficient reservoir pressure from compressor or dryer medium
- Park valve or relay valve not delivering full pressure low
Symptoms
- Red brake or low-air warning, parking brake indicator flashing
- Brakes dragging or spring brakes applying on their own
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C066F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.