C066E
Service/Park Brake Chamber Pressure Too High
C066E means the measured chamber pressure is higher than the module allows in the present state. No maker documents the code, so its limit is not public. Too much pressure in the service section raises the push on the brake directly: Bendix calculates about 1,800 lbf on the pushrod when 60 psi reaches a type 30 chamber, and its chamber tests are not to exceed 120 psig. A specific risk is compounding. A ZF patent from the WABCO family explains that adding service brake force on top of applied spring brakes can permanently damage downsized brakes, and uses the axle's service pressure to release the springs before that happens. Haldex's trailer EBS warns separately when reservoir pressure rises above 9.8 bar, pointing to a governor or valve fault upstream.
Possible causes
- Governor or pressure regulator letting system pressure rise too far medium
- Anti-compound function not working, both forces add up medium
- Pressure sensor reading too high low
Symptoms
- Brake warning or fault message on the dash or trailer lamp
- Harsh braking or overheated wheel ends after parking manoeuvres
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C066E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.