OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C066C

Right Rear Wheel Speed Sensor B Incorrect Component Installed

C066C indicates that the part on the second right rear speed channel differs from the one the module is set up for. No carmaker documents the code or its detection logic. Parts for the rear hub come in several versions: Schaeffler lists wheel bearings both with a multipole encoder and without one, plus third-generation units with the sensors built in, so a hub from the wrong range may lack the encoder or the second sensor altogether. Orientation matters too. NSK advises identifying the encoder side with a magnetic test card and fitting the bearing so that this face ends up next to the sensor; NTN-SNR suggests a paper clip for the same check. Since the code points to the part rather than to wiring, the fitted hub and sensor numbers are compared with the vehicle's specification first.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 6C

Possible causes

  • Hub or bearing from a variant without encoder or second sensor high
  • Bearing fitted with the encoder side facing away from the sensor medium
  • Sensor of another type or vehicle fitted medium

Symptoms

  • Warning appears right after work on the right rear hub
  • Redundant or automated brake functions not available

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C066C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication