C066A
Right Rear Wheel Speed Sensor B Intermittent/Erratic
C066A describes a second right rear speed signal that keeps dropping out or jumping. No carmaker documents it. Apart from loose contacts, the encoder deserves a close look. Schaeffler explains that many wheel bearings carry a multipole encoder just inside the seal: a ring magnetised in alternating poles that the sensor reads. NSK adds that this surface must not be pressed on during fitting and must be kept away from magnets and dirt. A ring with a cracked section, a spot of attracted metal swarf or a weakened pole produces a pulse train with gaps, which reads as an erratic speed rather than a dead channel. Such a ring cannot be repaired on its own when it is part of the bearing, so the bearing or hub has to be replaced.
Possible causes
- Encoder ring with metal swarf, cracks or weakened poles high
- Intermittent contact in plug or harness medium
- Worn wheel bearing letting the encoder wobble low
Symptoms
- Warning appears and clears again during a drive
- Speed of the right rear wheel jumps in live data
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C066A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- schaeffler.com/remotemedien/media/_shared_media/08_media_library/01_publications/automotiveaftermarket/brochure_1/download_4/saam_3/schaeffler-aftermarket-brochure-fag-radlager-en-7640.pdf
- nsk.com/eu-en/products/automotive/automotive-aftermarket/wheel-bearing-replacement/how-to-replace-a-wheel-bearing-with-magnetic-encoder-for-abs-cars/