C0667
Right Rear Wheel Speed Sensor B Range/Performance
C0667 reports that the second right rear speed signal arrives but is not plausible, while the circuit itself is fine. No maker documents the code. At the rear axle the air gap can change while driving. A Ford patent observes that on semi-floating axles the shaft can deflect by more than 0.5 mm, enough to push a Hall sensor out of range of its tone ring so the signal turns wrong or vanishes, especially on the more heavily loaded side in a turn. On non-driven rear axles with two tapered roller bearings, Schaeffler requires the bearing clearance to be set by the maker's specification; too much play spreads the load unevenly and makes the hub less rigid, which can likewise disturb the gap. Faults that come with load or cornering point in this direction.
Possible causes
- Worn or wrongly adjusted wheel bearing letting the gap vary high
- Axle shaft deflection under load or a bent shaft medium
- Sensor not fully seated in its bore medium
Symptoms
- Warning mainly with load, towing or in fast bends
- Stability control functions temporarily withdrawn
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0667
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.