C065B
Right Front Wheel Speed Sensor B Circuit High
In C065B the line of sensor B at the right front shows a level above its allowed window, which mostly means a short to the supply. TI's TPIC7218-Q1 sets this limit by sensor type: for active two-level sensors any current over 20 mA counts as overcurrent, for three-level VDA sensors only above 40 mA, in both cases marked as a possible short to battery. A separate flag reports a short to battery while the channel is switched off, and the supply switch caps current at 50 to 150 mA when the line is shorted to ground. Infineon's TLE5046SiC explains the wide band: its speed pulse alone may draw up to about 32 mA. Inspect the harness near hot or moving parts and for contact with another channel, then test the sensor. No carmaker documents C065B.
Possible causes
- Signal line shorted to battery voltage high
- Contact with the supply of another sensor channel in a shared cable medium
- Sensor draws excessive current due to internal damage low
Symptoms
- Warning for brake or driver assistance system
- Channel switched off by the module, redundant functions unavailable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C065B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.