C064F
Brake Pressure Sensor N Circuit Low
C064F: sensor N reports less than its smallest valid signal. In integrated units the sensor element and its evaluation are split: Continental Teves fits a bare measuring bridge into the hydraulic block and leaves amplification and offset to an IC in the module, while Actronics, which repairs such units, names the ATE MK60 with its internal pressure sensor as the system with the most pressure sensor problems and recommends repair or replacement of the unit rather than of a single sensor. A low reading can thus come from the sensor, the contacts or the module input. GM's 2016 hybrid brake module, for comparison, sets the low code of its left rear wheel pressure sensor below 0.3 V within 0.1 s. Nobody documents C064F or the letter N.
Possible causes
- Internal pressure sensor of the hydraulic unit failed high
- Signal contact or line shorted to ground medium
- Evaluation IC in the control module defective low
Symptoms
- ABS/ESC warning lamp on
- Stability control unavailable
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C064F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.