C064E
Brake Pressure Sensor N Circuit High
The signal of sensor N is above its permitted maximum. What the brake does next is described well for truck EBS: WABCO checks every analog pressure sensor signal against its authorised values; if one is lost, the module may keep producing electrical brake pressure by auxiliary means with limited accuracy, and if electronic control is impossible the axle falls back on purely pneumatic backup braking. For digital sensors the equivalent of a high reading is often a value pinned at full scale or a fault flag; Pico Technology notes that SENT frames carry a status nibble with diagnostic information and a CRC the receiver checks. C064E has no documented user, and nobody publishes which sensor N would be. Likely: short to supply, lost ground, failed sensor.
Possible causes
- Signal shorted to sensor supply or battery voltage high
- Open sensor ground medium
- Sensor electronics reporting full scale or an internal fault low
Symptoms
- Brake or ESC warning lamp on
- Less precise brake pressure control or pure backup braking
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C064E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.