C064C
Brake Pressure Sensor M Range/Performance
Sensor M stays inside its electrical window, but the pressure it reports is not believable. Trailer EBS shows an active test: when the control pressure exceeds 0.3 bar, WABCO's modulator switches its redundancy valve to reservoir pressure and starts EBS braking; during the stop it briefly switches back and uses its internal actual-pressure sensors to confirm that pneumatic pressure is present, otherwise it changes to purely pneumatic braking. Kelsey-Hayes lists in-range checks for hydraulic sensors: high pressure lasting unusually long, or high pressure while the brakes are not applied. No carmaker documents C064C or says which sensor is M. Possible causes: drift, a sticking valve, a leak, contamination in the sensor port.
Possible causes
- Sensor reading drifted from the true pressure high
- Valve in the measured circuit not switching as commanded medium
- Contamination or air at the sensor port low
Symptoms
- Warning lamp on after a brake application
- Braking switched to a backup mode with less precise pressure control
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C064C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.