OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C064B

Brake Pressure Sensor M Circuit Low

Sensor M sits below its lower signal limit. Because modules often supply several pressure sensors together, a single low code can be the visible part of a wider fault: WABCO's trailer modulator powers all active sensors jointly, so a short on one sensor supply can pull others down too, and codes for neighbouring letters may then appear at the same time. In an ESP block, Bosch describes each sensor with four contacts, two for supply and two for the analog pressure signal, which makes a shorted or contaminated spring contact a plausible cause. GM's 2019 brake module flags its secondary circuit pressure sensor low under 4.61 % of supply for 100 ms; no maker publishes C064B itself. Check the shared supply before replacing sensor M.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 4B

Possible causes

  • Shared sensor supply shorted, pulling several sensors low high
  • Signal line or contact of sensor M shorted to ground medium
  • Sensor element failed low

Symptoms

  • Warning lamp on, possibly with further pressure sensor codes
  • Electronic brake functions reduced to a fallback mode

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C064B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication