OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0649

Brake Pressure Sensor M Circuit/Open

The circuit of brake pressure sensor M, the twelfth in the series, has no continuity. Where so many pressure inputs exist, they are often not reachable from outside: WABCO notes that the two rear axle pressure sensors of its truck EBS are wired inside the axle modulator, so the cabling cannot be tested from outside and a fault means work on the modulator. Passenger-car units behave similarly; Actronics points out that the ATE MK60 carries its brake pressure sensor inside the unit, while some VW models use separate sensors near the master cylinder. External sensors, as on WABCO's trailer brake, take their supply from the modulator through a plug. No carmaker assigns C0649 or the letter M. Check plug and terminals first, then the unit.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 49

Possible causes

  • Loose or corroded plug at an external sensor or at the modulator high
  • Open in the internal wiring of the modulator or hydraulic unit medium
  • Broken wire in the sensor harness low

Symptoms

  • Brake or ABS warning lamp on
  • Electronic pressure control replaced by a fallback mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0649

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication