C0648
Brake Pressure Sensor L Range/Performance
Sensor L delivers an electrically valid signal whose pressure does not fit the situation. Commercial vehicle EBS shows how such a check works with many sensors: WABCO's tractor EBS has pressure sensors in the front axle relay valve, in each channel of the rear axle modulator and in the trailer control valve. During normal braking the left and right rear pressures must almost match, and a deviation beyond the permitted value is stored as a fault. Each sensor carries individual calibration data; in Continental's process they are matched to its serial number and stored in the module, so a mismatch after a repair could also appear as an offset. No carmaker documents C0648 or the letter L. Look for drift, trapped pressure, a sticking valve or a leak.
Possible causes
- Sensor offset or gain drifted high
- Sticking valve, leak or trapped pressure in the measured circuit medium
- Calibration data not matching the fitted sensor after a repair low
Symptoms
- ABS/ESC warning lamp on, sometimes only after several brake applications
- Uneven or reduced electronic brake force distribution
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0648
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.