OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0647

Brake Pressure Sensor L Circuit Low

Sensor L reads below its lowest valid value. In the Kelsey-Hayes scheme a near-zero bridge output is read as a probable short, because the sensor never reaches 0 V with a working circuit. Where the fault lies depends on the architecture: in a Continental Teves design the sensor in the hydraulic unit is only a bare Wheatstone bridge, and amplifier, offset correction and digitising sit in an IC on the control module, so a low reading can start on the board just as well as in the sensor. That patent also loads the factory calibration of each sensor, tied to its serial number, into the module. Typical causes: signal shorted to ground, collapsed sensor supply, damaged bridge. Which part a system calls L is not public; C0647 has no documented carmaker.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 47

Possible causes

  • Signal path shorted to ground high
  • Sensor supply missing or pulled down medium
  • Amplifier or input stage in the brake control module defective low

Symptoms

  • ABS/ESC warning lamp on
  • Brake assist and stability control unavailable

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0647

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication