C0645
Brake Pressure Sensor L Circuit/Open
C0645 reports lost continuity in the circuit of brake pressure sensor L, the eleventh letter of the series because I is not used. That is far beyond a normal car: a Bosch patent names one, three or five sensors as the usual ESP layouts and calls five the current maximum. No carmaker publishes which sensor would carry the L. Where it does exist, the sensor is often clinched straight into the valve block, and Continental and Bosch both describe its four contacts (supply, ground, two signal pads) touching spring contacts on the module board instead of a harness. An open is then frequently a bent spring, a corroded pad or a crack inside the unit, not a broken wire. Expect the ESC and ABS lamps; ordinary braking is kept.
Possible causes
- Spring contact between sensor and module board bent, dirty or corroded high
- Plug or harness of an externally mounted sensor without continuity medium
- Internal interruption in sensor L low
Symptoms
- ESC and ABS warning lamps on
- Pressure-based functions such as brake assist or hill hold unavailable
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0645
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.