C0644
Brake Pressure Sensor K Range/Performance
The voltage from sensor K is in range, yet the pressure is not believable. Bendix's EC-80 stores a plausibility error when the primary and secondary brake demand sensors disagree and asks for a static calibration after an ECU swap. Mercedes' SBC repeats self-tests about every 16 brake applications, pressurising the calipers to check sensors, valves and leaks; if the system fails, two valves stay open so pedal force acts on the brakes directly. A Bosch patent keeps an offset fault stored, with ABS and ESC lamps lit, until a later good check on a roughly straight drive passes. No manufacturer documents C0644 or says which sensor K is. Look for drift, air, a leak or a valve that does not close.
Possible causes
- Sensor K offset or gain drifted high
- Sensor values not re-learned after module replacement medium
- Leak, air or a valve that does not seal distorting the pressure medium
Symptoms
- ABS and ESC lamps on until a later successful check
- Stability control reduced, pedal may feel different in fallback mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0644
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.