C0643
Brake Pressure Sensor K Circuit Low
Sensor K reports less voltage than any valid pressure would give. Bendix's truck ESP treats brake demand and load sensors individually and, if one of them fails, disables only ESP while ABS and traction control carry on; this graded reaction shows why the code may leave basic ABS working. GM's 2016 hybrid module compares the wheel pressure signal with ground and sets its low code under 0.3 V within 0.1 s. Denso points out that a broken supply wire reads exactly like this when the module pulls its input down, so a low code does not rule out an open. Which sensor K would be is not published by any carmaker. GM's PIP5094 keyword list contains C0643 from its old numbering, unrelated to this sensor.
Possible causes
- Signal line shorted to ground high
- Broken sensor supply read as 0 V through the input pull-down medium
- Sensor K without output low
Symptoms
- ESC lamp on, ESC switched off
- ABS and traction control may keep working
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0643
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.