C0641
Brake Pressure Sensor K Circuit/Open
Brake pressure sensor K has an open circuit. Because the letter I is skipped in this series, K stands for a tenth pressure sensor, which is rare in cars; no carmaker publishes C0641 and the assignment is unknown. Heavy vehicles show how many pressure inputs one brake ECU can have: Bendix's EC-80 ESP reads a brake demand sensor in each of the two air circuits plus a load sensor and keeps a separate open-or-shorted code for each; ESP is then switched off while ABS and traction control stay active. In passenger cars the sensor often plugs straight into the module, as in a Kelsey-Hayes design, which removes harness opens but not contact faults. Honeywell notes that the resulting level after an open depends on whether the input has a pull-up or a pull-down resistor.
Possible causes
- Poor contact between sensor and module or harness connector high
- Open conductor where an external harness is used medium
- Internal open in sensor K low
Symptoms
- ESC or ABS warning lamp on
- Stability control off, basic ABS may remain available
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0641
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.