OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0640

Brake Pressure Sensor J Range/Performance

C0640 marks sensor J as valid in voltage but wrong in content. In plunger-based brakes the pressure can be cross-checked against what the actuator did: Ipgate compares delivered piston volume with the pressure-volume curve and closes the inlet valves one by one to find a leaking circuit, while Continental's one-box layout carries separate sensors for master cylinder and pressure supply that can be set against each other. GM's 2016 hybrid module re-zeroes its wheel pressure sensor only while the pedal is released and reports a correction larger than ±1,500 kPa. A circuit leak, air or a seized valve can therefore set C0640 as well as a drifting sensor. No maker documents this code publicly; PIP5094 lists C0640 under GM's old numbering.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 40

Possible causes

  • Sensor J drifting so its zero correction exceeds the limit medium
  • Leak or air in the brake circuit so pressure and delivered volume disagree medium
  • Inlet or isolation valve seized low

Symptoms

  • Brake warning and ESC lamps on
  • Longer pedal travel or reduced brake boost in fallback mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0640

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication