C063F
Brake Pressure Sensor J Circuit Low
The signal of brake pressure sensor J is stuck below its lower limit. Ipgate's double-stroke-piston patent fits one pressure sensor to each brake circuit and checks the delivered fluid volume against the pressure-volume curve of that circuit; such a circuit sensor is one possible J position, though no manufacturer confirms the letter. Denso defines 0–0.3 V as the low fault band and notes that a broken feed or signal line also lands there when the input has a pull-down. Saab/GM detects a ground short or open on the signal or 5 V reference after 0.1 s and then turns off ABS, traction and stability control for the rest of the ignition cycle. Usual suspects: a chafed signal wire, a shorted reference, a failed sensor element.
Possible causes
- Chafed signal wire touching ground high
- 5 V reference shorted to ground medium
- Broken feed or signal wire pulled to 0 V by the module input medium
- Failed sensing element in sensor J low
Symptoms
- ABS, traction and stability warning lamps on
- ABS and ESC inoperative until the next ignition cycle
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C063F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.