C063E
Brake Pressure Sensor J Circuit High
C063E: sensor J sends more voltage than its range allows. GM's 2016 hybrid brake controller shows the method on a wheel pressure sensor: if the signal line exceeds 3.3 V and so no longer differs from the supply, a short to supply is stored after 0.1 s with the ignition on, rated Type A. Denso's patent explains the second route: with a pull-down at the input, an open sensor ground forms a divider that pushes the line beyond 4.7 V. No public source says which part is sensor J; brake-by-wire units such as Bosch Motorsport's EBS already measure axle, driver, caliper and master cylinder pressure separately. A falsely high value would look like braking that is not happening, so the module discards the signal and limits its functions.
Possible causes
- Signal line shorted to the sensor supply medium
- Sensor ground interrupted, output lifted through the input divider medium
- Sensor J electronics failed with output stuck high low
Symptoms
- Brake or ESC warning lamp on
- Live data shows brake pressure although no one is braking
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C063E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.