C063D
Brake Pressure Sensor J Circuit/Open
A wire or contact of brake pressure sensor J is interrupted. No manufacturer ties C063D to a specific sensor. Continental's one-box brake patent names sensors for the master cylinder and for the pressure supply unit and mentions optional further ones for brake circuits or wheel brake circuits, so a J sensor could be among those. Bosch Motorsport's EBS illustrates per-channel fault flags: internal axle pressure, internal master cylinder pressure and the external caliper and master cylinder sensors each have their own bit. GM's 2019 EBCM does not separate an open from a short to voltage at all; both end up as open or shorted high above 95.24 % of supply. So check plug, terminals and harness first, even if the stored code says high instead of open.
Possible causes
- Spread or corroded terminal in the sensor connector high
- Conductor interrupted between sensor and control unit medium
- Open circuit inside sensor J low
Symptoms
- Brake system or ESC warning lamp on
- Pressure-controlled brake functions switched off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C063D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.