C063B
Brake Pressure Sensor H Circuit Low
C063B says sensor H reads below its valid floor. Unlike C063C the problem is electrical, not a believable but wrong pressure. A Bosch workshop article on a Teves MK60 unit describes the integrated sensor: fed with 5 V, it stays below 1 V with the brakes off and climbs as pedal pressure builds, so the fault limit has to sit well under that rest level. GM's 2019 EBCM flags its circuit pressure sensor as shorted low when the main channel falls under 4.61 % of supply, or the reference channel under 4.85 %, for 100 ms. Where H sits is not published; in Toyota's eight-sensor design the candidates would be a wheel cylinder, the booster chamber or the pump output. Likely: signal shorted to ground, collapsed 5 V reference or a dead sensor.
Possible causes
- Signal conductor shorted to ground high
- 5 V reference collapsed by a short in another sensor on the same feed medium
- Sensor H without output due to an internal defect medium
Symptoms
- ABS and ESC lamps on
- Brake assist and stability control not available
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C063B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.