C063A
Brake Pressure Sensor H Circuit High
The output of pressure sensor H is too high to be real. C063A is not documented by any carmaker. Another Toyota patent shows seven pressure points in one brake: accumulator, two master cylinder passages and four control pressures standing for the wheel cylinders. Which of them a system might label H is not public. An excessive signal usually means the line touches a voltage source or the sensor ground is lost; some sensors also park their output at the top on purpose, as Honeywell's MIP transducers do at 97.5 % of supply after an internal fault or overpressure. Saab's 9-5 ESP sets its pressure sensor code above 4.75 V within 0.1 s and also checks that the sensor supply stays between 4.4 and 5.6 V. Measure ground and feed at the plug before replacing parts.
Possible causes
- Signal line touching a 5 V or battery feed medium
- Sensor ground open or high resistance medium
- Sensor reports an internal fault or overpressure at its upper rail medium
Symptoms
- ABS/ESC warning lamp on, ESC unavailable
- Implausibly high brake pressure in live data at rest
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C063A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- patents.google.com/patent/US9919690B2/en
- prod-edam.honeywell.com/content/dam/honeywell-edam/sps/siot/ja/products/sensors/pressure-sensors/industrial-pressure-sensors/mip-series/documents/hon-ia-hss-mip-series-high-pressure-datasheet-en.pdf
- saabwisonline.com/9-5-9600/2010/5-brakes/stabiliser-system-esp/fault-diagnosis-diagnostic-trouble-codes/c0131