C0639
Brake Pressure Sensor H Circuit/Open
Brake pressure sensor H has lost its electrical connection: an interrupted 5 V feed, signal or ground line, or a loose plug at the hydraulic unit. No published service data ties C0639 to a real part. Layouts with eight sensors do exist: a Toyota patent places pressure sensors at the pump and accumulator output, ahead of the pressure-increasing valve, in the master cylinder and booster chambers and at all four wheel cylinders. With a pull-down input, Denso shows that a cut supply or signal line ends at 0 V while a cut ground climbs above 4.7 V, so an open may surface as C063B or C063A instead. Kelsey-Hayes plugs its sensor straight into the module board to avoid a harness and watches for an open or shorted bridge; on a failure ABS is disabled and a lamp lit.
Possible causes
- Sensor plug loose or terminals corroded high
- Supply, signal or ground conductor broken medium
- Open measuring bridge or failed electronics inside the sensor low
Symptoms
- ABS and ESC lamps on, possibly flickering with vibration
- ABS or stability control disabled
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0639
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.