C0638
Brake Pressure Sensor G Range/Performance
Here sensor G produces a voltage inside its window, but the pressure it reports disagrees with what the system expects. Lucas/ZF describe the classic test for multi-sensor EHB units: after the driver brakes to a stop, the isolation valve stays closed and all wheel valves open, so three or more sensors share one pressure; the odd one out is the faulty sensor, with size and direction of its error. Two sensors alone would only reveal that something is wrong. A Bosch patent learns offsets while driving, flags a fault once the correction grows beyond a threshold and keeps ABS lamp and ESC telltale lit until a later good check. No manufacturer documents C0638; GM's PIP5094 contains the number from an earlier GM scheme. Causes: drift, trapped pressure, a sticking valve.
Possible causes
- Zero point or gain of sensor G drifted high
- Pressure trapped in the circuit during the comparison or zero learn medium
- Valve sticking so the sensor does not see the shared test pressure low
Symptoms
- ABS lamp and ESC telltale on
- Stability control reduced or off, regenerative braking possibly limited
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0638
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.