OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0637

Brake Pressure Sensor G Circuit Low

C0637 reports that sensor G delivers less voltage than its lowest valid reading. Brake pressure sensors keep a live zero at rest, so a signal near 0 V means a fault rather than zero pressure: Saab's 9-5 ESP flags a pressure signal under 0.25 V lasting 0.1 s, and GM's 2016 hybrid brake module treats under 0.3 V for 0.1 s on its left rear wheel pressure sensor (sensor D there) as a short to ground, Type A. Common causes are a signal wire chafed through to the body, a 5 V reference pulled down, or a failed sensor. Which component G is stays open; in a seven-sensor unit like the Lucas/ZF design it would be one of the wheel, supply or push-through sensors. G usually sits in the hydraulic block, so a sensor defect often means replacing that block.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 37

Possible causes

  • Signal wire chafed and shorted to ground high
  • 5 V sensor reference shorted to ground or interrupted medium
  • Sensor G defective, often only replaceable with the hydraulic unit medium

Symptoms

  • ABS and ESC warning lamps on
  • Live data shows no pressure even when the pedal is pressed

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0637

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication