OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0635

Brake Pressure Sensor G Circuit/Open

C0635 flags a broken circuit at brake pressure sensor G: a supply, signal or ground wire without continuity, or a plug that has lost contact. No manufacturer publishes C0635 in this meaning, so it is unknown which part carries the letter G. A seventh sensor only exists in large units, for example the Lucas/ZF electro-hydraulic layout with four wheel sensors, one supply sensor and two front push-through sensors. What the module reads after an open depends on its input: per Honeywell, losing feed or ground sends the signal to the top rail if the input is pulled up, to the bottom if it is pulled down. Saab/GM books such an interruption after 0.1 s and switches off ABS and stability control. GM's PIP5094 lists C0635 from an older, unrelated GM numbering.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 35

Possible causes

  • Plug at the sensor or hydraulic unit loose, corroded or with pushed-back terminals high
  • Broken supply, signal or ground wire in the sensor harness medium
  • Internal interruption inside sensor G low

Symptoms

  • ABS and ESC warning lamps on
  • Stability control and pressure-based brake functions switched off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0635

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication