C0632
Front Axle Disconnect Control Circuit
C0632 concerns the electrical path that drives the front axle disconnect, not the shift itself. The actuator may be electromagnetic or electromechanical; BorgWarner's patent even reads its position from the coil's inductance, which changes between engaged and released. Ford's Explorer and Aviator actuator has a four-wire connector. No maker publishes C0632; Stellantis uses its own codes, and its STAR cases show where such faults sit: on 2019–2021 Ram heavy-duty trucks damaged wires within 6–8 inches of the FAD connector, on Ram 1500 a check of harness and connector before the actuator is replaced, and on the Jeep Wrangler a signal below 1.19 V for 500 ms from moisture in a 34-way connector; the actuator then keeps its position.
Possible causes
- Chafed or cut wires close to the actuator connector high
- Water or corrosion in the actuator or inline connector medium
- Spread or pushed-out terminals in the connector medium
- Open or shorted actuator winding low
Symptoms
- 4WD/AWD service message or warning lamp
- Front axle does not engage or disengage
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0632
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.