OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0631

Front Axle Disconnect Actuator

A front axle disconnect separates the front shaft from the driveline when only the rear or primary wheels need to drive, cutting drag; a BorgWarner patent shows a shift fork sliding a splined sleeve, with a cone synchroniser matching speeds first. Ford uses C0631 in the AWD module of 2020–2021 Explorer and Aviator built up to 30 Aug 2021: the powertrain malfunction (wrench) lamp comes on, often with C00A6, and the cause is the disconnect actuator and intermediate shaft. TSB 23-2114, later 23-2174, 25-2373 and 25-2568, swaps them for a redesigned intermediate shaft without disconnect, seals off the four-wire pigtail, fits a new halfshaft and updates the AWD module, at 2.0–7.8 h depending on engine.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 31

Possible causes

  • Failed disconnect actuator or intermediate shaft (Ford Explorer/Aviator 2020–2021) high
  • Loose, corroded or damaged actuator connector medium
  • Shift sleeve or synchroniser binding, often from wear or fluid problems medium
  • Outdated AWD module software low

Symptoms

  • Wrench or 4WD/AWD warning lamp on
  • All-wheel drive not available or front axle does not engage
  • Possible noise from the front axle area

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0631

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication