C062E
Active Air Dam Supply Voltage Circuit Low
The active air dam actuators run from the vehicle battery while the PCM or body module commands them over LIN or CAN, as Ford's patent lays out. C062E reports that the supply reaching the actuator or its module is too low to move the panel safely. Small LIN motor drivers made for flaps and grille shutters watch this themselves: Melexis' MLX81350 has an undervoltage threshold selectable between about 4 and 9 V. Stellantis shows a related field case on the Ram 1500: lost contact with the air dam plus system-voltage-low codes in several modules, traced to loose grounds G921/G933/G904 and fluid wicking into inline connector XY110A. No maker publishes C062E. The panel stops where it is until supply recovers.
Possible causes
- Loose or corroded ground point in the front harness high
- Water or washer fluid wicking into an inline connector medium
- Weak battery or low charging voltage medium
- High resistance in fuse or feed wire to the actuator low
Symptoms
- Air dam no longer moves and stays in its last position
- Air dam fault message in the cluster
- Low-voltage codes in other modules at the same time
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C062E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.