C0624
Variable Effort Steering Sensor Circuit
Variable effort steering tunes hydraulic assist to the situation, and besides road speed some systems also read a steering wheel sensor. Ford's variable-assist steering, first used on the 1988 Lincoln Continental, fed its module from an optical sensor tracking how the wheel turns; a Ford patent describes that encoder with 20 slots and two detectors, good for 4.5° steps, and drops the actuator current during quick evasive turns so full assist comes back. A GM patent adds a handwheel angle input to Magnasteer control. C0624 is the general electrical fault in this sensor circuit: broken signal wire, lost feed or ground. No maker publishes C0624. Effort then follows road speed alone, or the system falls back to one fixed level.
Possible causes
- Loose or corroded connector at the steering column sensor high
- Wire broken where the harness flexes in the steering column medium
- Failed sensor, for example a dead optical detector medium
Symptoms
- Steering effort no longer reacts to quick wheel movements
- Effort stays at one level or follows only road speed
- Steering warning on some vehicles
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0624
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.