C0623
Variable Effort Steering Lock/Safety Actuator Control Circuit Performance
C0623 covers a lock or safety actuator whose circuit is sound but whose action does not match the command: it does not release when energised, does not engage in time, or its current is implausible. JTEKT's lock coil first gets full duty for about one second to pull the arm free, then 60 % below 13 V or 40 % above 14 V to hold it, which keeps the coil at or below 100 °C instead of near 200 °C. GM's active steering patent switches to the mechanical lock if electrical locking has not taken effect within about 42 ms. A worn lock pin, a sticky arm, a weak spring or a hot coil can each upset such timing. No maker publishes C0623; the variable steering function is switched off until the code clears.
Possible causes
- Sticking lock arm or pin, worn lock teeth high
- Solenoid weakened by heat, pull-in force too low medium
- Low supply voltage during release medium
- Weak or broken return spring, lock engages late low
Symptoms
- Steering warning and variable function off
- Clicking or knocking from the steering column at start or stop
- Steering wheel slightly off-centre after the system locks
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0623
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.