C0621
Variable Effort Steering Lock/Safety Actuator Control Circuit Low
C0621 reports the lock or safety actuator line held too low. In JTEKT's variable-ratio design a PNP transistor switches the lock coil, and the ECU holds the line low on purpose when it wants to lock, for instance after a motor or sensor fault or a broken cable. An unintended short to ground therefore looks like a permanent lock request: the solenoid cannot lift the arm, and the steering stays mechanically coupled. GM's active front steering patent locks the motor electrically first and falls back to the mechanical lock if that has not happened within about 42 ms. No maker publishes C0621. The car steers normally but without the variable feature, and a warning appears.
Possible causes
- Lock solenoid wire shorted to ground in the column or gear harness high
- Shorted turns in the lock solenoid medium
- Failed drive transistor in the steering module low
Symptoms
- Variable ratio or effort function off
- Steering warning lamp or message
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0621
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.