C061E
Variable Effort Steering Actuator Control Circuit High
C061E means an actuator line reads above what the controller expects, typically a lead shorted to battery voltage or a driver stage stuck on. Delphi describes Magnasteer as electronically modulating the magnetic torsional rate, with coil polarity deciding whether effort rises or falls; a line stuck high can therefore hold the actuator in one direction or stop the bridge from regulating. Ford's older variable-assist valve shows the other pattern: no current means a wide open valve and full assist, while 550 mA at 80 mph closes it. A bridge IC like the DRV8873-Q1 recognises a short to the supply and turns off. No maker documents C061E. The driver feels steering effort that no longer tracks speed.
Possible causes
- Actuator lead shorted to a battery-fed wire high
- Output transistor in the module stuck on medium
- Wrong pinning after a steering gear swap low
Symptoms
- Unusually heavy or unusually light steering that does not change with speed
- Steering warning message on some vehicles
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C061E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.