C061D
Variable Effort Steering Actuator Control Circuit Low
C061D flags an actuator line held too low, most often a coil lead shorted to the steering gear housing or to the vehicle body. The Magnasteer coil sits in the cast valve housing, which forms part of its magnetic circuit, so insulation damage there grounds the winding; checking each coil terminal against the housing is a standard test. Because the current must flow in both directions, the controller uses a full bridge, and drivers such as the DRV8874-Q1 shut down on overcurrent when an output is grounded. With the actuator dead, assist depends solely on torsion bar stiffness and the pump's delivery. No maker publishes C061D; open and high are C061C and C061E.
Possible causes
- Actuator coil insulation broken down to the steering gear housing high
- Actuator wire chafed against subframe or exhaust heat shield medium
- Failed output stage in the controlling module low
Symptoms
- Speed-dependent steering feel lost
- Steering feels the same at all speeds
- Fuse for the steering actuator may blow
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C061D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.