OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C061A

Brake Pedal Position Sensor B Offset Exceeded Learning Limit

C061A is the same learn-limit check for the second channel, B. Many pedal sensors hold two independent elements; on GM trucks since 2012 one potentiometer feeds the ECM and the other the BCM, each with its own 5 V reference, ground and signal. Each controller keeps its own released-position value and updates it whenever it sees a lower voltage, so a short dropout on one channel can leave B with a skewed zero while A stays correct. The Hitachi patent rejects a learned zero outside its prescribed range as a sensor fault. Snap-on and GM's 16-NA-155 stress relearning in both modules without touching the pedal. Which physical channel a maker calls B is not public, and no maker documents C061A; channel A is C0619.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 1A

Possible causes

  • Dropout or fretting corrosion on the channel B reference, ground or signal pin high
  • Learn done in only one module, or the pedal moved during the learn medium
  • Pedal rest position changed by a mat, bracket damage or adjustment medium
  • Drifting second element inside the pedal sensor low

Symptoms

  • Brake system warning or message
  • Mismatch between modules about pedal state, e.g. brake lights versus cruise control
  • Shift interlock or start function may act up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C061A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication