C0618
Park Brake Control Module Control Circuit High
C0618 is the overvoltage counterpart of C0617: the feed or control line of the parking brake electronics reads above its window. A regulator fault in the alternator or DC/DC converter, jump starting with a booster set to 24 V, or a short between the enable line and a live wire are the usual reasons. Mitsubishi's ABS unit sets C10B7-17 once the ignition feed reaches 16 V or more, with a detection delay of up to one second, and the parking brake is then locked out. In GM's 2025 EBCM tables a motor voltage above 18 V for 700 ms halts the motor and blocks further actuation, logged as C0616. No maker publishes C0618. Check charging voltage with the engine running before blaming the brake module.
Possible causes
- Faulty voltage regulator in the alternator or DC/DC converter high
- Overvoltage from a jump starter or charger on a 24 V setting medium
- Enable or control line shorted to a battery-fed wire low
Symptoms
- Parking brake warning lamp, possibly with a battery or charging warning
- Parking brake does not respond to the switch
- Other modules may log overvoltage codes at the same time
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0618
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.