C0613
Right Park Brake Actuator Performance/Stuck Off
C0613 covers a right actuator that is powered but fails to clamp. The wiring is intact, yet the module never sees the motor turn or the current rise that marks pads pressed against the disc. Mitsubishi gives a concrete case with C10B0-09 on the 2023 Outlander PHEV: during apply the right motor does not rotate, and after ten seconds or more the ABS unit flags it and disables both the parking brake and hill start assist. Bosch patents read clamping force from motor current, so a flat current curve points to a slipping belt, stripped gear or idle spindle; ZF's actuator drives the spindle through a belt and a gearbox. FMVSS 135 requires the parking brake to hold a loaded car on a 20 % grade. No maker publishes C0613; the left twin is C060E.
Possible causes
- Stripped gear, slipping belt or broken spindle inside the right actuator high
- Motor seized by corrosion after water entry medium
- High resistance in the right circuit starving the motor of current medium
- Pads or disc worn far beyond limit, or caliper not calibrated after a brake job low
Symptoms
- Parking brake warning lamp and message
- Parked vehicle may creep on a slope
- No motor noise from the right rear when the brake is applied
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0613
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.