OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0612

Right Park Brake Actuator Control Circuit High

With C0612 a lead of the right parking brake motor stays at or near battery voltage while the bridge tries to pull it low. Likely causes are a short to a live wire in the rear harness, a wrong splice after body or axle repair, or a defect in the output stage. Driver ICs such as the DRV8873-Q1 treat a short to the supply as its own protected fault and disable the output. GM's PIT5662A, written for park brake messages on the Acadia, XT5, Enclave and Traverse, has technicians measure both rear circuits at the brake module with the actuators plugged in; a reading above 6 ohms means wiring or actuator repair. No maker publishes C0612. The right brake keeps its last position, and a parking brake warning lights up.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 12

Possible causes

  • Motor lead shorted to a battery-fed wire in the rear harness high
  • Failed low-side switch in the control unit holding the lead high medium
  • Wrong pin or splice after an earlier harness or body repair low

Symptoms

  • Service parking brake message and warning lamp
  • Right parking brake does not respond to the switch
  • Code may return as soon as an apply is commanded

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0612

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication