C060F
Left Park Brake Actuator Stuck On
C060F is the reverse of C060E: the left actuator does not release, or the module cannot confirm that it has. An Advics patent recognises release by watching motor current while the motor runs backwards: once the current stops changing after a minimum time of around 200 ms, the clamping force is taken as zero and the motor runs on briefly to set pad clearance. A release that never shows this pattern, or a motor that stalls, fits a stuck-on fault. Seized pistons, a corroded spindle nut, pads frozen to the disc or a broken gear stage are typical. ZF's workshop guide requires the scan tool maintenance mode before the actuator unit is replaced. Driving with the brake applied overheats the rear brake.
Possible causes
- Seized caliper piston or corroded spindle nut high
- Pads frozen or rusted to the disc after standing medium
- Broken gear stage in the actuator medium
Symptoms
- Left rear brake drags, smells hot or the car pulls away sluggishly
- Park brake lamp stays on after release
- Release message or refusal to drive off
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C060F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.