C0607
Steering Wheel Angle Sensor Circuit High
C0607 is the mirror image of C0606: the steering angle signal sits above its allowed ceiling. Usual reasons are a signal wire shorted to the sensor supply or to battery voltage, an open ground at the sensor, after which the line drifts up, or an internal fault driving the output to its top end. In the Kelsey-Hayes quadrature sensor a valid high state is near 4.4 V and readings beyond the upper limit are faults; in the Bosch PWM concept a line stuck at battery level yields no valid duty cycle, and the patent names a short to battery as detectable. HELLA points out that a redundant double angle sensor lets such single-channel failures be caught. No maker publishes C0607. The ESC lamp lights and stability control stays off until the fault is gone.
Possible causes
- Signal wire shorted to the sensor supply or battery voltage high
- Open sensor ground, signal floats high medium
- Sensor output stage failed high medium
Symptoms
- ESC and traction control warning lamps on
- Steering angle shown at an implausible maximum value
- Lane keeping or park assist switched off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0607
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.