OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0606

Steering Wheel Angle Sensor Circuit Low

C0606 flags a steering angle signal or sensor supply that reads too low, as caused by a short to ground, a sagging supply or an output stuck at the bottom of its range. In the Kelsey-Hayes design the two phase lines swing between roughly 0.6 V and 4.4 V on a 5 V feed, and anything below the lower band is a fault; Bosch's PWM sensor maps −720° to +720° onto 10–90 % duty cycle, so a line pinned to ground leaves that window, and the patent lists a short to ground as detectable. Sensors that talk over CAN, such as the Bourns type 6002 running on 8–18 V, report their errors on the bus instead. No maker documents C0606 publicly. Stability control shuts down; after repair the centre position may need relearning.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number6 / 06

Possible causes

  • Signal wire chafed against the steering column and shorted to ground high
  • Low sensor supply from a weak battery or a damaged feed circuit medium
  • Sensor output stage failed low medium

Symptoms

  • ESC warning lamp on and stability control unavailable
  • Steering angle in scan data pinned at one end value
  • Driver assistance messages about limited function

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0606

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication