C0600
4WD/AWD Range Actuator Position Control Error
The position loop that drives the range actuator to a target does not reach or hold it: commanded and measured position stay apart for too long, although sensor and drive circuit pass their own checks. Magna describes such a loop for a transfer case range shift, with speed profiles per shift phase and PID control over the last tenth of travel down to a stop at the target. Lear's actuator patent notes that the feedback should stop the worm gear at about 270 degrees but can overrun towards the 330 degree stop. Typical causes are binding, a weak motor, low voltage or poor learned limits. GM used C0600 earlier for a suspension accelerometer (PI0954, 2010 LaCrosse); that is a different, older assignment. No maker documents C0600 in this meaning.
Possible causes
- Stiff range fork, cam or shift rail slows the actuator high
- Weak shift motor or low supply voltage medium
- Learned end positions no longer match the hardware medium
- Play between sensor target and shift mechanism low
Symptoms
- Range shift incomplete, indicator flashes
- 4WD service message and range shifts blocked
- Noise from the transfer case while the motor hunts for position
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0600
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.