OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05FF

4WD/AWD Range Actuator Position Not Learned

The controller lacks valid reference positions for the range actuator, so it cannot translate sensor readings into high, neutral and low. GM full-size trucks run such a relearn at every start-up: per PIP5089A the transfer case module drives the encoder motor to locate its position, and if a sensor, motor or circuit problem prevents this it sets C0569 and runs no further checks. Lear's actuator patent shows why the limits matter, as about 270 degrees of worm gear travel are used inside a 330 degree mechanical range and a full turn could lock the transfer case. A Honda and Denso patent for a similar shift actuator falls back to driving against both end stops when sensor data are unusable. New actuators, modules or lost memory are typical triggers. No maker documents C05FF itself.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / FF

Possible causes

  • Actuator or control module replaced without running the learn routine high
  • Learn routine aborted by a sensor, motor or wiring fault medium
  • Stored values lost after battery disconnection or low voltage medium

Symptoms

  • 4WD service message right after a repair
  • Range shifts unavailable until the learn has run
  • Range indicator flashes at start-up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05FF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication