C05FD
4WD/AWD Range Actuator Position Sensor Circuit Low
The range actuator position signal sits below the lowest value an intact sensor can deliver. With a sensor powered from a reference supply this usually means the signal line is shorted to ground, the supply is missing or the sensor output has failed low. Fixed diagnostic bands are common for such position inputs; a Honda and Denso patent for a comparable shift range actuator treats any sensor voltage at or below 0.5 V as abnormal. Sensors with PWM output, as in Magna's transfer case design, show the same fault as a duty cycle stuck at the lower limit. GM bulletin PIP5098 points to a corroded ground terminal for the encoder motor channels on Colorado and Canyon. No maker documents C05FD itself; C05FE is the opposite case.
Possible causes
- Signal wire shorted to ground high
- Missing sensor reference supply medium
- Sensor output failed low medium
Symptoms
- 4WD service message, range shifts disabled
- Range indicator shows no valid position
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05FD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.