OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05FB

4WD/AWD Range Actuator Position Sensor Circuit

General electrical fault in the circuit of the sensor that reports where the range actuator stands, without narrowing it to low, high or implausible. Designs vary: Magna mounts a programmable linear Hall IC on the transfer case housing that reads a stepped sector plate or the range fork and outputs a duty cycle; BorgWarner uses a single sensor whose probe rides five plateaus on the cam; GM full-size trucks combine rotary and incremental position sensors in the encoder motor. Stellantis files comparable faults under the separate SAE codes C00A7-13 and C00A8-13 (actuator position sensor A or B circuit open), triggered in bulletin 08-237-23 by an unseated connector. No maker documents C05FB itself; C05FD and C05FE are the narrower variants.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / FB

Possible causes

  • Sensor or actuator connector not fully latched high
  • Open supply, ground or signal wire of the position sensor medium
  • Failed position sensor, often integrated in the shift motor medium

Symptoms

  • 4WD service message, range shifts disabled
  • Range indicator blank or flashing
  • Further transfer case codes stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05FB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication