OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05F7

4WD/AWD Range Actuator Control Circuit Low

A range actuator drive line sits below its expected voltage, typically because a motor lead is shorted to ground or the driver pulls it down when it should not. In a reversing gear motor each terminal is alternately the high and the low side, so a ground short on either lead shows up depending on shift direction. The TI DRV8873-Q1 is an example of a driver that reports a short to ground separately from overcurrent and open load and shuts the affected half-bridge off. Ford advises in SSM 48300 to inspect Super Duty transfer case connectors for damaged wires before condemning the motor; Magna's patent shows the motor turning a screw and sector shaft to move the range fork, so without drive the fork stays put. No maker documents C05F7; C05F8 is the high-side fault.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / F7

Possible causes

  • Motor lead chafed through and shorted to the body or transfer case high
  • Water or corrosion in the shift motor connector medium
  • Internal short in the shift motor medium
  • Faulty low-side driver in the control module low

Symptoms

  • 4WD service message, range change refused
  • Fault may appear only when shifting in one direction
  • Blown fuse for the transfer case motor possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05F7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication