C05F6
4WD/AWD Range Actuator Control Circuit Performance
The drive circuit of the range actuator is electrically present, but the response does not match the command: motor current, run time or achieved travel fall outside the window the controller expects. Magna describes a range shift motor driven by pulse width modulation in phases, fast to neutral, slower through synchronisation at about 55 to 80 percent of travel, and under PID position control from about 90 percent. A circuit with high resistance or a weak supply cannot follow such a profile. GM bulletin PIP5098 for Colorado and Canyon traces intermittent 4WD faults to a poor ground terminal for the encoder motor, easiest to reproduce under high electrical load while cranking and shifting. No maker documents C05F6 itself; mechanical binding is C05FA.
Possible causes
- High resistance in ground or supply of the motor circuit high
- Weak battery or low system voltage during the shift medium
- Worn shift motor drawing abnormal current medium
- Degraded driver stage in the control module low
Symptoms
- Range shifts slow or incomplete
- Intermittent 4WD service message, often when cold or at start-up
- Shift attempt aborted, transfer case returns to previous range
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05F6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.